Plan of Macgregor M saloon Table

by **r.fairman** » Sat Mar 24, 2012 6:20 am

Does anyone have an accurate Plan of the Macgregor 26M saloon Table that I can have

regards

richard

by **RobertB** » Sat Mar 24, 2012 9:19 am

Do you just need a drawing of the existing table? Or is this something other than stock you are looking for? If stock, I can measure mine, should be easy.

by **r.fairman** » Sun Mar 25, 2012 1:25 am

I need the dimensions of the stock table the shape is some sort of trapesoid

thanks

by **c130king** » Sun Mar 25, 2012 4:08 am

I am about to drive over to the marina for day of potentiallly rainy sailing. I will take some measurements. But my Dad and I remade the table from my :macm:

. It is exactly the same size but over 2" thick as it has a lift top for storing charts and paperwork inside. And it has fiddles on the edge. I had intended to get a sheet of plexiglass so I could put a chart on the table and then cover it with plexi...the fiddles would hold it in place. But I never did that.

Cheers,
Jim
Sailing on König
Sailing on König YouTube Channel

by **mdeane** » Sun Mar 25, 2012 6:20 am

c130king wrote:

I am about to drive over to the marina for day of potentiallly rainy sailing. I will take some measurements. But my Dad and I remade the table from my . It is exactly the same size but over 2" thick as it has a lift top for storing charts and paperwork inside. And it has fiddles on the edge. I had intended to get a sheet of plexiglass so I could put a chart on the table and then cover it with plexi...the fiddles would hold it in place. But I never did that.

Cheers,
Jim
Sailing on König
Sailing on König YouTube Channel

Can your tabletop design still be used as the starboard berth filler board?

Marc

by **mdeane** » Sun Mar 25, 2012 6:32 am

r.fairman wrote:Does anyone have an accurate Plan of the Macgregor 26M saloon Table that I can have

regards

richard

My 2005 M tabletop is 39 1/2" x 30" . The front corners are 8" radius quarter rounds.

Marc

by **c130king** » Sun Mar 25, 2012 4:02 pm

mdeane wrote: Can your tabletop design still be used as the starboard berth filler board?

Marc,

I don't think so. I have never put the original table or the new table in that position...and I don't have the cushions for it either. But the new table is probably about 2 inches taller/thicker than the standard table and that is not counting the 1/2" high fiddles.

Cheers,
Jim

Plan of Macgregor M saloon Table

Plan of Macgregor M saloon Table

Re: Plan of Macgregor M saloon Table

Re: Plan of Macgregor M saloon Table

Re: Plan of Macgregor M saloon Table

Re: Plan of Macgregor M saloon Table

Re: Plan of Macgregor M saloon Table

Re: Plan of Macgregor M saloon Table

Who is online