My 7ft cabin top genny tracks

I resolved that issue yrs ago by just using a skate board to cross that distance faster before I lost my balance ! now I just use knee pads ! :( :) :P , BWY , was posting a mod a few yrs back that extended the 2 stanchion's on the cabin roof & installing a solid s/s bar between them did that eve...

FYI this is an add that was originally produced few yrs ago & I believe the owner at the time of the adds production was a member of this site at that time & did post a review about how it came into the production of the add , now I,m not 100% sure about if this owner was a site member or I ...

I already had an old piece of Alum flat bar left over from a previous mod i used for the gate cover & I believe used a piece of old plastic cutting board cut to fit as the filler 3 holes in cover r tapped threaded for s/s screws to hold the filler in place flush so as not to interfere with the s...

I made my own mast gate

https://i.postimg.cc/dv79qMgS/20210901-143549.jpg

https://i.postimg.cc/CSGrgTqp/20210901-143541.jpg

easy peasy

J

If u r doing alot of hiway trailering I went with comercial rated radials away more weight rating than needed with a much stronger tread & wall belt rating allowing for much higher speed rating & helps cut down on swaying with the stronger belted sidewalls & will never likely have a blow...

I believe the Manuall says if u r going to leave the boat in the water for more than 6wks at a time u should put some kind of protection on it to prevent this issue . from 2008 to 2016 I gave my boat 2 coats of wax each spring & her hull always looked as good & smooth as the day I picked her...

J

Some things should never b deleted



J

stove top kettle to boil water




one hot water bottle each
or spooning is another option


J

Hi sailors All the best to u all in health , wisdom , love , wealth & Family

J

Russ wrote: ↑Wed Jun 19, 2024 6:01 am I don't think my bimini has much effect on the point of sailing. Of course I usually raise the iron genny when the wind gets too high.

Russ,
I think u mean lower "the Iron Genny" unless u r running an air foil Prop instead of an water foil prop off ur O/B

J

Hi do u have a pic showing more of the mast if it is only the mast grove that is damaged "dented" a hardwood wedge slightly wider than the grove driven in halfway from the top & then the bottom very slowly while using an electric heat gun to preheat the mast should do the trick . Inser...

Fabricated a hutch on the galley for more usable space & storage








J

I installed three hatches for easier access https://i.postimg.cc/WFXxMRWm/20160320-172437-Copy.jpg https://i.postimg.cc/1gMvdGGs/20160320-172451.jpg https://i.postimg.cc/Ff2YNqgZ/20160320-172541.jpg https://i.postimg.cc/r0NrVTyk/20160320-172703.jpg https://i.postimg.cc/F77VZfsk/20160320-173015.jpg h...